slacky.eu

Codice: Seleziona tutto

neo@Neo:~$armyops 
Xlib:  extension "GLX" missing on display "Neo:0.0".
Xlib:  extension "GLX" missing on display "Neo:0.0".
Signal: SIGSEGV [segmentation fault]
Aborting.


Crash information will be saved to your logfile.
X Error of failed request:  BadColor (invalid Colormap parameter)
  Major opcode of failed request:  79 (X_FreeColormap)
  Resource id in failed request:  0x100000c
  Serial number of failed request:  105
  Current serial number in output stream:  107
neo@Neo:~$glxgears
Xlib:  extension "GLX" missing on display "Neo:0.0".
glxgears: Error: couldn't get an RGB, Double-buffered visual.

Codice: Seleziona tutto

neo@Neo:~$glxgears
Xlib:  extension "GLX" missing on display "Neo:0.0".
glxgears: Error: couldn't get an RGB, Double-buffered visual.

Codice: Seleziona tutto

# **********************************************************************
# Graphics device section
# **********************************************************************

# Any number of graphics device sections may be present

# Standard VGA Device:

Section "Device"
    Identifier  "Standard VGA"
    VendorName  "Unknown"
    BoardName   "Unknown"

# The chipset line is optional in most cases.  It can be used to override
# the driver's chipset detection, and should not normally be specified.

#    Chipset    "generic"

# The Driver line must be present.  When using run-time loadable driver
# modules, this line instructs the server to load the specified driver
# module.  Even when not using loadable driver modules, this line
# indicates which driver should interpret the information in this section.

    Driver     "vga"
# The BusID line is used to specify which of possibly multiple devices
# this section is intended for.  When this line isn't present, a device
# section can only match up with the primary video device.  For PCI
# devices a line like the following could be used.  This line should not
# normally be included unless there is more than one video device
# intalled.

#    BusID      "PCI:0:10:0"

#    VideoRam   256

#    Clocks     25.2 28.3

EndSection

# Device configured by xorgconfig:

Section "Device"
    Identifier  "GeForce FX5700Le"
    Driver      "nv"
    #VideoRam    256
    # Insert Clocks lines here if appropriate
EndSection

Codice: Seleziona tutto

# **********************************************************************
# Monitor section
# **********************************************************************

# Any number of monitor sections may be present

Section "Monitor"

    Identifier  "Acer AL1711"

# HorizSync is in kHz unless units are specified.
# HorizSync may be a comma separated list of discrete values, or a
# comma separated list of ranges of values.
# NOTE: THE VALUES HERE ARE EXAMPLES ONLY.  REFER TO YOUR MONITOR'S
# USER MANUAL FOR THE CORRECT NUMBERS.

    HorizSync   31.5 - 82.0

#    HorizSync  30-64         # multisync
#    HorizSync  31.5, 35.2    # multiple fixed sync frequencies
#    HorizSync  15-25, 30-50  # multiple ranges of sync frequencies

# VertRefresh is in Hz unless units are specified.
# VertRefresh may be a comma separated list of discrete values, or a
# comma separated list of ranges of values.
# NOTE: THE VALUES HERE ARE EXAMPLES ONLY.  REFER TO YOUR MONITOR'S
# USER MANUAL FOR THE CORRECT NUMBERS.

    VertRefresh 50-90

EndSection