Pagina 1 di 1
configurazione lilo
Inviato: mer 14 set 2005, 10:55
da giaco31
salve, ho due partizioni di linux, una in hda1 e l-altra in hda2, devo configurare manualmente lilo per mostrarle entrambe al bootloader, cosa devo scrivere...
grazie a tutti!
Inviato: mer 14 set 2005, 10:57
da -Shark-
Inviato: mer 14 set 2005, 11:00
da giaco31
# LILO configuration file
# generated by 'liloconfig'
#
# Start LILO global section
boot="/dev/hda"
message = /boot/boot_message.txt
prompt
timeout="1200"
# Override dangerous defaults that rewrite the partition table:
change-rules
reset
# VESA framebuffer console @ 1024x768x256
vga="773"
# Normal VGA console
# vga = normal
# VESA framebuffer console @ 1024x768x64k
# vga=791
# VESA framebuffer console @ 1024x768x32k
# vga=790
# VESA framebuffer console @ 1024x768x256
# vga=773
# VESA framebuffer console @ 800x600x64k
# vga=788
# VESA framebuffer console @ 800x600x32k
# vga=787
# VESA framebuffer console @ 800x600x256
# vga=771
# VESA framebuffer console @ 640x480x64k
# vga=785
# VESA framebuffer console @ 640x480x32k
# vga=784
# VESA framebuffer console @ 640x480x256
# vga=769
# End LILO global section
# Linux bootable partition config begins
image="/boot/vmlinuz"
root="/dev/hda1"
label="Linux"
read-only
image ="/boot/vmlinux"
root="/dev/hd2"
label="Ubuntu"
read-only
# Linux bootable partition config ends
quando provo a salvare m,i dice che il file non e" ok..
Inviato: mer 14 set 2005, 11:06
da epd20
quando provo a salvare m,i dice che il file non e" ok..
non si capisce cosa vuoi dire. quando esegui /sbin/lilo ti dà errore?
[edit] tra l'altro attaccati all'altro post, è meglio [/edit]
Inviato: mer 14 set 2005, 11:55
da giaco31
ho risolto, era un errore di battitura...