ho fatto così
ma non naviga.# modprobe pppoe
#pppoe-setup
#pppoe-start
e si connette.
poi
#/sbin/route del default
#/sbin/route add default dev ppp0
ifconfig
eth0 Link encap:Ethernet HWaddr 00:0B:6A:B0:1D:E0
inet addr:192.168.1.1 Bcast:192.168.1.31 Mask:255.255.255.224
inet6 addr: fe80::20b:6aff:feb0:1de0/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:117 errors:0 dropped:0 overruns:0 frame:0
TX packets:127 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:7089 (6.9 KiB) TX bytes:5370 (5.2 KiB)
Interrupt:16 Base address:0xd400
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:76 errors:0 dropped:0 overruns:0 frame:0
TX packets:76 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:6574 (6.4 KiB) TX bytes:6574 (6.4 KiB)
ppp0 Link encap:Point-to-Point Protocol
inet addr:87.3.255.2 P-t-P:192.168.100.1 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1
RX packets:9 errors:0 dropped:0 overruns:0 frame:0
TX packets:4 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:324 (324.0 b) TX bytes:37 (37.0 b)
dmesg | grep eth
eth0: SiS 900 PCI Fast Ethernet at 0xd400, IRQ 16, 00:0b:6a:b0:1d:e0.
eth0: Media Link On 100mbps full-duplex
eth0: no IPv6 routers present
avvio in questo modoroute -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.100.1 0.0.0.0 255.255.255.255 UH 0 0 0 ppp0
192.168.1.0 0.0.0.0 255.255.255.224 U 0 0 0 eth0
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo
0.0.0.0 192.168.1.1 0.0.0.0 UG 1 0 0 eth0
poi una cosa strana: all'avvio il login è testuale. entro, ma quando voglio spegnere o riavviare, non li trovo, c'è solo termina sessione. quindi termino e di nuovo modalità testuale. non è che si avvia in failsafe mode, o qualcosa del genere?ciao!"kernel (hd1,6)/vmlinuz-huge-smp-2.6.21.5-smp root=/dev/hdb7"