ragazzi non riesco a configurare i vari componenti che si abilitano da tasi FN+
il problema principale eè la connessione wifi ed ethernet.
posto i vari risultati .
Codice: Seleziona tutto
bash-4.1# ifconfig -a
eth0 Link encap:Ethernet HWaddr 00:21:85:55:E5:3F
inet6 addr: fe80::221:85ff:fe55:e53f/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:23 errors:0 dropped:0 overruns:0 frame:0
TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1842 (1.7 Kb) TX bytes:468 (468.0 b)
Interrupt:42 Base address:0xe000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:188 errors:0 dropped:0 overruns:0 frame:0
TX packets:188 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:14640 (14.2 Kb) TX bytes:14640 (14.2 Kb)
wlan0 Link encap:Ethernet HWaddr 00:21:85:77:C6:2D
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:17 Memory:f8660000-f8660100 Codice: Seleziona tutto
bash-4.1# dmesg |grep eth
7.110844] r8169 0000:01:00.0: eth0: RTL8102e at 0xf865e000, 00:21:85:55:e5:3f, XID 14a00000 IRQ 42
16.075246] r8169 0000:01:00.0: eth0: link down
36.566663] ADDRCONF(NETDEV_UP): eth0: link is not ready
296.862414] r8169 0000:01:00.0: eth0: link up
296.863490] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
307.434070] eth0: no IPv6 routers present
Codice: Seleziona tutto
bash-4.1# iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wlan0 802.11b/g Mode:Managed Access Point: Not-Associated
Bit Rate:11 Mb/s
Retry:on RTS thr:off Fragment thr:off
Encryption key:off
Power Management timeout:0us mode:All packets received
Link Quality=0/100 Signal level=0 dBm Noise level=0 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Codice: Seleziona tutto
bash-4.1# lsmod
Module Size Used by
btusb 10073 0
bluetooth 47805 1 btusb
rfkill 13278 1 bluetooth
snd_seq_dummy 1119 0
snd_seq_oss 25900 0
snd_seq_midi_event 4696 1 snd_seq_oss
snd_seq 42680 5 snd_seq_dummy,snd_seq_oss,snd_seq_midi_event
snd_seq_device 4505 3 snd_seq_dummy,snd_seq_oss,snd_seq
snd_pcm_oss 34554 0
snd_mixer_oss 14726 1 snd_pcm_oss
ipv6 236629 14
cpufreq_ondemand 7672 2
speedstep_lib 2663 0
acpi_cpufreq 5195 1
freq_table 2039 2 cpufreq_ondemand,acpi_cpufreq
mperf 923 1 acpi_cpufreq
ppdev 4901 0
lp 7105 0
parport_pc 18218 0
parport 25627 3 ppdev,lp,parport_pc
fuse 58136 1
snd_hda_codec_realtek 222970 1
i915 360914 2
snd_hda_intel 18443 0
snd_hda_codec 61720 2 snd_hda_codec_realtek,snd_hda_intel
drm_kms_helper 23927 1 i915
snd_hwdep 4772 1 snd_hda_codec
drm 143170 3 i915,drm_kms_helper
snd_pcm 59843 3 snd_pcm_oss,snd_hda_intel,snd_hda_codec
usbhid 32435 0
snd_timer 15717 2 snd_seq,snd_pcm
i2c_algo_bit 4287 1 i915
psmouse 40986 0
rtc_cmos 7970 0
i2c_i801 7018 0
processor 23158 1 acpi_cpufreq
hid 63771 1 usbhid
i2c_core 16421 5 i915,drm_kms_helper,drm,i2c_algo_bit,i2c_i801
snd 43891 11 snd_seq_oss,snd_seq,snd_seq_device,snd_pcm_oss,snd_mixer_oss,snd_hda_codec_realtek,snd_hda_intel,snd_hda_codec,snd_hwdep,snd_pcm,snd_timer
video 10482 1 i915
wmi 7129 0
thermal 6718 0
evdev 7303 16
intel_agp 9000 1 i915
thermal_sys 11426 3 video,processor,thermal
rtc_core 11871 1 rtc_cmos
serio_raw 3542 0
r8169 32377 0
battery 8431 0
hwmon 1065 1 thermal_sys
r8187se 148817 0
rtc_lib 1502 1 rtc_core
soundcore 4641 1 snd
intel_gtt 11414 3 i915,intel_agp
ac 2465 0
button 4005 1 i915
mii 3334 1 r8169
snd_page_alloc 5925 2 snd_hda_intel,snd_pcm
eeprom_93cx6 1004 1 r8187se
agpgart 23062 3 drm,intel_agp,intel_gtt
output 1456 1 video
sg 21511 0 
