Codice: Seleziona tutto
neo@Neo:~$armyops
Xlib: extension "GLX" missing on display "Neo:0.0".
Xlib: extension "GLX" missing on display "Neo:0.0".
Signal: SIGSEGV [segmentation fault]
Aborting.
Crash information will be saved to your logfile.
X Error of failed request: BadColor (invalid Colormap parameter)
Major opcode of failed request: 79 (X_FreeColormap)
Resource id in failed request: 0x100000c
Serial number of failed request: 105
Current serial number in output stream: 107
neo@Neo:~$glxgears
Xlib: extension "GLX" missing on display "Neo:0.0".
glxgears: Error: couldn't get an RGB, Double-buffered visual.
Codice: Seleziona tutto
neo@Neo:~$glxgears
Xlib: extension "GLX" missing on display "Neo:0.0".
glxgears: Error: couldn't get an RGB, Double-buffered visual.
Codice: Seleziona tutto
# **********************************************************************
# Graphics device section
# **********************************************************************
# Any number of graphics device sections may be present
# Standard VGA Device:
Section "Device"
Identifier "Standard VGA"
VendorName "Unknown"
BoardName "Unknown"
# The chipset line is optional in most cases. It can be used to override
# the driver's chipset detection, and should not normally be specified.
# Chipset "generic"
# The Driver line must be present. When using run-time loadable driver
# modules, this line instructs the server to load the specified driver
# module. Even when not using loadable driver modules, this line
# indicates which driver should interpret the information in this section.
Driver "vga"
# The BusID line is used to specify which of possibly multiple devices
# this section is intended for. When this line isn't present, a device
# section can only match up with the primary video device. For PCI
# devices a line like the following could be used. This line should not
# normally be included unless there is more than one video device
# intalled.
# BusID "PCI:0:10:0"
# VideoRam 256
# Clocks 25.2 28.3
EndSection
# Device configured by xorgconfig:
Section "Device"
Identifier "GeForce FX5700Le"
Driver "nv"
#VideoRam 256
# Insert Clocks lines here if appropriate
EndSection
Codice: Seleziona tutto
# **********************************************************************
# Monitor section
# **********************************************************************
# Any number of monitor sections may be present
Section "Monitor"
Identifier "Acer AL1711"
# HorizSync is in kHz unless units are specified.
# HorizSync may be a comma separated list of discrete values, or a
# comma separated list of ranges of values.
# NOTE: THE VALUES HERE ARE EXAMPLES ONLY. REFER TO YOUR MONITOR'S
# USER MANUAL FOR THE CORRECT NUMBERS.
HorizSync 31.5 - 82.0
# HorizSync 30-64 # multisync
# HorizSync 31.5, 35.2 # multiple fixed sync frequencies
# HorizSync 15-25, 30-50 # multiple ranges of sync frequencies
# VertRefresh is in Hz unless units are specified.
# VertRefresh may be a comma separated list of discrete values, or a
# comma separated list of ranges of values.
# NOTE: THE VALUES HERE ARE EXAMPLES ONLY. REFER TO YOUR MONITOR'S
# USER MANUAL FOR THE CORRECT NUMBERS.
VertRefresh 50-90
EndSection
